Splat balls, also known as water beads or gel balls, are small, colorful, water-absorbing polymer beads used in various activities, including as ammunition for toy guns. To make splat ball ammo grow faster, you can follow these steps:
1. Properly Soak the Splat Balls:
- Start by ensuring that the splat balls are clean and free of any dirt or debris.
- Place the splat balls in a container or bowl.
- Add enough clean, room-temperature water to fully submerge the splat balls. Use purified or tap water without any additives.
- Allow the splat balls to soak in the water for an adequate amount of time. The exact time needed may vary depending on the brand and type of splat balls, but it typically takes a few hours to overnight for them to reach their maximum size.
2. Stir Occasionally:
- Occasionally stir or agitate the splat balls gently while they are soaking. This helps ensure that all sides of the balls come into contact with the water, promoting even absorption and faster growth.
3. Check and Remove Excess Water:
- After the splat balls have soaked for the recommended time, check their size. They should have grown significantly in size compared to their original dry form.
- If there is excess water in the container, carefully drain it or use a strainer to separate the expanded splat balls from the water.
4. Use the Proper Water-to-Splat Ball Ratio:
- Make sure you are using the correct amount of water for the number of splat balls you have. Using too much water can slow down the growth process.
5. Store Properly:
- If you have leftover splat balls after they have fully expanded, store them in a sealed container with a small amount of water to keep them hydrated and prevent them from drying out and shrinking.
6. Be Patient:
- Some types of splat balls may take longer to reach their maximum size than others. Patience is essential, so give them the necessary time to grow.
Keep in mind that the exact instructions for your specific type of splat balls may vary, so it’s a good idea to check the packaging or manufacturer’s recommendations for the most accurate guidance. Additionally, avoid using hot water, as it can damage the splat balls or cause them to grow too quickly and burst.